Tag: Blogger

 

from Blogger http://ift.tt/2G2t3Qq
via IFTTT

The other day I tried a variation on the on-bike 360° photography I’ve previously done.  Rather than mount the camera on a flexible tripod on the front of the bike, I attached a carbon monopod to the rear top-box rack, extended it and put the camera on top.


The bottom part of the monopod had a screw in point.  With that removed I could bolt this very light weight, carbon fibre monopod to the rear luggage rack (which itself is attached to the frame) very securely.  In almost an hour of riding on typically lousy rural Ontario roads both the camera and monopod were very secure and the photos showed no evidence of wobble or blur.


These are the parts used:

• Neewer carbon fibre monopod from Amazon (about fifty bucks)
• Ricoh Theta 360SC camera from Amazon (under $250CAN)

With the camera over a metre above and behind my head, the three-sixty degree pinched perspective makes the bike and I look quite far away:

After doing a round at full extension (the monopod extends to just over five feet or 160cms), I reduced the bottom leg.  I couldn’t see the results of the shots until I got back and I was worried that the full extended monopod would produce wobble and blur or be structurally stressed (it didn’t and it wasn’t).  The monopod only weighs a couple of hundred grams and can hold 10 kilos or 22 pounds of gear – the Theta weighs less than a hundred grams.


With the camera reset closer to four feet above the back deck of the bike I did some more miles, including riding over some very rough roads.  Even in those circumstances the rig was solid, unmoving and took sharp photos, even in the relatively poor light (it had been heavily overcast, foggy and raining on and off all day).

The pavement leading up to the West Montrose Covered Bridge is particularly rough, but even then the photos were clear and sharp.

Good horizons on such a tall camera mount, and this is at the lower setting.

With the camera set so much higher, corners don’t seem as dramatic.  When the camera is mounted on the rear view mirror it turns with the handlebars, amplifying the lean effect.

Perhaps the best example of the camera’s lack of wobble was the shot from inside the covered bridge.  On an overcast, dim day in a poorly lit environment with the bike bouncing over rough pavement, the sharpness is still surprisingly good.  This was so dim that I had to raise the sun visor in the helmet:

This is a photo uploaded to the Theta 360 site and modified with the little planet geometry tool.

I’d call this a successful test.  Setting up this kind of monopod on a Givi tail mount for a top box works really well.  The monopod base fits snuggly in the tail mount, which is a very solid, over engineering piece of kit designed to carry potentially heavy luggage.  The monopod takes a big quarter inch bolt.  I used a big washer on the bottom and a smaller one that fit perfectly inside the lattice on the top of the rack.  With the monopod tightened down with a ratchet it was extremely secure.


The camera didn’t wobble on full extension, but with the monopod retracted one level (the shortest, narrowest one at the bottom) the monopod rubber met the top of the luggage lattice and it was even stronger.  With the camera on the shortened tripod, the photos still offered a surprisingly distant perspective:

With the monopod shortened one level it’s still well above six feet off the deck (I’m 6’3″).

It’s another unique perspective to pursue with 360° on-motorcycle photography, but I have to say, I think it feels a bit alienating because everything is so distant and you can’t see the rider’s face.  Short of flying a drone perilously close to a rider, there is no other way you could get this perspective though…

One of the few sunny moments on the ride – you can see the monopod’s shadow on the road.

Something like this might look really cool on a bike doing a wheelie, or someone knee down in a canyon.  It also does a nice job of capturing the surroundings, but unless I’m looking for shots that are more about the scenery than the ride, I doubt I’ll be doing it again.  I prefer the more intimate and exciting angles you get from mounting the camera closer and in front of the rider:

from Blogger https://ift.tt/2NFyhBu
via IFTTT

What I’d upgrade equipment-wise if I had my druthers:

360 Cameras

Ricoh Theta Z1:  most 360 cameras are built for action video and make photography an afterthought.  The Z1 is a photography first tool with the largest sensor, raw image file options and a quality of image quality rather than quantitity.  It’s expensive, but if you’re into 360 photography and especially exploring the edges of it, the Z1 is the tool.

Cost:  $1350

GoPro Max 360 Camera:  I’ve chewed up a few Thetas doing action photography.  The GoPro Max is pretty much everything proof and produces quality 360 images, though it is (like most 360 cameras) video focused.

At 16.6 mega-pixels the Max produces nice images, and the time lapse photography option would work well for on-bike photography.

It’d be nice to have an on-bike camera that I could just leave filming when the rains come.  I currently have to get the dainty Theta out of the way whenever the weather sets in.

Cost:  $730

Aerial/Drone Photography

DJI Mini 2:  I’ve got a Phantom 2 and it’s a fine thing, but it’s big and increasing restrictions on drone flight make it more and more difficult to fly.  You can get around most of that by flying a micro drone (under 250 grams), which don’t require the same restrictions.

There are super cheap options with poor cameras and disposable air-frames, but the Mini-2 borrows the best tech from its big brothers in a small, foldable package that travels well.

Cost:  $520

Digital SLR Camera Updates

Canon 6D Mk2  SLR camera body:  I’m still enjoying my Canon Rebel T6i and I’d want an more advanced camera body that would still let me use the lenses I’m familiar with.  The 6D is the next step on from the entry level Rebel cameras with improved features and range.  Stepping up doesn’t come cheap though, though it would still be able to use my current lenses.

They describe my Rebel as a ‘beginner’ camera, though I’ve won competitions against ‘pros’ with ‘pro’ cameras, but the marketing does mess with my pride.

Body Cost:  $1800

CANON EF 100MM F2.8 L MACRO IS USM LENS

I love macro photography and use the Canon basic macro lens on the Rebel.  This is the stop up full-frame lens for the 6D.

It would have to be next level because this lens alone costs more than my current camera body with a tele, prime and macro lens.

$1700

SIGMA 24-70MM F2.8 DG OS HSM CANON (ART)

Another lens that by itself costs more than all the lenses I currently have.  DSLR shooting out of the ‘beginner’ cameras is for the privileged.

$1600

CANON EF 70-200MM F2.8L IS III USM LENS

If you think the others are dear, here’s your telephoto, and only up to 200mm, for less than most of my motorcycles have cost.

$2700

I’d like more reach with a full frame camera but pro-really long telephotos start to get into same-price-as-a-car money.  I’ve explored Olympus’s DSLR alternatives and enjoyed owning super-zoom all-in-one cameras too.  Super zooms have come a long way in recent years.  Sony’s DSC-RX10MIV  has a massive 1 inch CMOS sensor promising good low light photography while also offering an astounding 24-600mm reach on a built in lens.   Rather than chuck thousands at lenses and DSLR bodies (and then have to lug it all around), maybe a next-gen all-in-one super zoom should be next, though if this is a wish list then the money wouldn’t matter.

Rather than flash “pro” kit around, I’m looking for ways to innovate my photography.  A full-frame DSLR would be nice, but for a fraction of the cash I could get myself a current micro-drone, a powerful super-zoom and the latest in 360 camera technology, which even with all my experience with, I still feel like I’m only just scratching the surface.

In a variation on photography, I’ve also previously explore 3d scanning with the first gen Structure Sensor.  Their current PRO model is $695 (US) and comes out this summer.  That’d also be on my short-list of ‘imaging tools’.

If I avoided the DSLR money-pit, I’d be into five and half grand in the latest imaging tools (360 cameras, drone, big sensor all-in-one super-zoom and 3d scanner).  That’s 1/3 the price of a single ‘pro’ level telephoto lens.  Wish list or not, I think I can do more interesting things with digital imaging with a more diverse set of tools.

from Blogger https://ift.tt/YvWmpgK
via IFTTT